Here is my fourth yarn turtle spun on my 3D printed Turkish style spindle using Southdown wool.

I was hoping to make a three ply yarn from the Southdown wool, but I think I have enough roving for one more turtle, which will give me 5 turtles, which is not easily divisible by 3. I could chain ply, but I find that difficult with turtles, especially toward the end. I could two-ply, then cable ply by plying the two-ply together to make a four ply, which gives an interesting texture and results in very little waste. I could weigh the yarn and rewind it all into three even amounts. So many choices.

I think, when the spinning is done, I shall do some small lengths of each type of plying, to help me decide what to do over all.