Going back to a pumpkin contest in 2016, here is my hand crafted pumpkin cover of Mama Bear of the Berenstain bears.
It probably really isn’t in the spirit of pumpkin carving, but at the time we lived in such a humid environment that pumpkins started rotting on day 1. The library would host an uncarved pumpkin contest (paint and glued decorations only) to avoid the rot. I rather like the crocheted cover, it is reusable.
Happy Halloween.
Using offset square knots I made a pouch beneath the macrame design I did earlier to hold a tongue drum.
The idea is to create more storage for small musical instruments on either side. Knotting continues.
I put American Bison wool insoles from the Buffalo Wool Company in my shoes to help give them some cushion, and I knew I would need to keep them up and away from the cat. Thor the cat loves natural wool, and he loves my shoes, so I was taking a large gamble combining the two. For a couple weeks I was very good about keeping the shoes up on the shoe rack, then I was reminded why when I set my shoes on my chair before my morning walk and came back to a suspiciously happy cat cuddled in next to the shoes.
The insoles remain unmolested, but I must be vigilant.
So doilies are round and flat, and berets start out round and flat, so if I find a pretty doily pattern that might work for a beret, right? Um, depends. I found a pattern with a flower center that was quite attractive as a doily. When translated to larger yarn, I had the necessary width before the center flower was done, resulting in a beret with symmetrical holes, rather than a lovely lace.
Back to the drawing board. I’m starting to see the end of the bag of gifted acrylic yarn though!
I finished spinning Egyptian cotton single spun yarn onto three bobbins on an Ashford Traveller spinning wheel (Yes! I spun cotton on a wheel using a high speed whorl.) I found the largest diameter on the high speed whorl, the one that matches the bobbin end diameter, worked best for me. The smaller diameter gears went too fast and I over spun. I also had the wheel set up with Scottish tension with a very light take up on the bobbin. I prefer to dictate the amount of spin in my yarn rather than have it controlled by the wheel.
The next task was to ply the cotton. I was nervous about this because the singles had a high degree of twist, and liked to kink up. If a strand broke I would also be dealing with the rapid unwinding of the single, which results in a whole sale unbinding of a large section of yarn (ask me how I know). I did let the singles sit on the bobbin for a few days to set the twist a little. Remarkably, I was able to ply the yarn from the three bobbins with no breakage and only a few missed kinked knots.
My spinning definitely looks like homespun, but as I practiced, my technique improved and there were some sections of smooth and even spun yarn.
Critters and Craft 