Tag: silk

Yarn cake

On By CarynIn Craft

I have spun and plied all my blended fiber from Anniewhere. The blend is Merino wool, Blue-faced Leicester, Alpaca, Tussah silk, and Finn wool. I bought 6 oz and have been using it to test different spindles, so I’m frankly amazed that it turned out somewhat consistent. I joined the skeins with a braided join: split each end in two, then remove one of the four resulting ends, braid those three together, then moisten and roll between your palm. Here is a video.

Photo description: yarn cake on a yarn winder with two additional skeins on a PVC niddy noddy in the background.
Photo description: finished yarn cake sitting on a scale reading 5.3 oz.

I joined all the skeins together because I intend yo do a knitted project. I spotted a free ruffled scarf pattern while I was spinning, and knew that it would be great for my yarn, so the pattern has been sitting with the fiber. I’m excited to cast on. (I’m might have to admit that I could be a knitter.)

Found!

On By CarynIn Craft

I knew I had another box of blended fiber by Anniewhere, and I found it while looking for what to spin next in my prepped fiber box! Yay! I think I’ve spun 4 oz of this blend so far, which consists of Merino wool, Blue Faced Leichtester, Alpaca, Tussah Silk, and Finn Wool. I’ve been using it to test out different spindles, so I continued that and dug out a 3D printed Turkish spindle that I bought at a fiber festival. It spins beautifully and even though I have to use a half hitch at the top, rather than a hook or notch, I haven’t been dropping it as much as I feared.

Photo description: From the top, a rosewood ring distaff with cord and handkerchief, a 3D printed Turkish spindle with turned wood shaft and the start of a yarn turtle, bakery box full of carded and blended fiber.

I even used a small ball of a single spun from the same fiber that was left over from plying to start the yarn turtle, and in so doing had a gauge for how thin to spin, and saved more yarn from the scrap bin!

Making drop spindles

On By CarynIn Craft

I’ve been working on a new drop spindle. I like my previous student spindles, but they are on the light side, just over an ounce. This light weight can be more challenging, so I wanted something a little heavier for upcoming spinning classes. I sourced some beautifully made wooden whorls from Pinehurst, TX, (yes, they are marketed at toy wheels, but they make lovely whorls) and some locally obtained dowels to make the shafts.

Sand paper, carved shafts with end notch, and Pinehurst crafts wheels

The whorls are lovely, but with the 12” shafts, the weight tipped over the two ounce mark, which is heavier than I wanted. To lighten the load, I drilled out material with my drill press and a 1/2” drill bit.

Marking whorls with a template to evenly space five holes

Then came the sanding and finishing. I sanded each piece down to 600 grit, wet the wood and let it dry, then sanded with 600 grit again. Both the whorl and shaft are finished with a clear matte coating to protect from stains. The most delicate part of the spindle is where the screw hook engages the wood, so I wrap the shaft with beeswax coated silk thread to strengthen.

Finished spindles with different colored silk wrap

These spindles can be used as a top whorl with hook, or flipped over and used as a bottom whorl drop spindle with the notch to keep a half-hitch in place. I’ve tested both ways and am pleasantly surprised how long these spin! The finished weight on all of them is around 2 ounces.